Your cart is empty
Welcome, Log In   |   Create a New Account

Bare linear LED driver 1400mA

  • Model: AMC7135_1400MA
  • Shipping Weight: 1g
  • Units in Stock: 29

$3.00  $1.00
Save: 67% off

This pre-built module will drive a single 3-watt high power LED at 1400mA from a battery or power supply of up to 6 volts.

The unit consists of a tiny circular PCB around 17mm in diameter and 3mm high. It has four AMC7135 driver ICs on board, plus a reverse protection diode so you can't hurt the board if you connect it up backwards. The ICs feature output open and short circuit protection and a dropout voltage of just 120mV.

On the back of the board are two copper areas which would normally act as battery contacts. Just connect your power source to these and the LED to the contacts on the front. The LED anode goes to the centre hole, the cathode to the empty solder pad next to it.

Originally designed for torch conversions, these are ideal for building into your own equipment.


Add to Cart:


This product was added to our catalog on Thursday 19 July, 2012.

Your IP Address is: 3.80.224.52
wabusiness template