RGB and multicolour LEDs

These are a 5mm RGB fast animating LEDs with an attached 1.5 volt booster circuit and short flying leads. They will run from any voltage between 0.8 to 1.6V DC, making them ideal for use with 1.2 and...

These RGB LEDs have a fast speed fading sequence that changes colour every 0.5 seconds or so - very eyecatching. But unlike our regular RGB LEDs, these have an inbuilt resistor for use on up to 13V,...

These RGB LEDs have a slow speed fading sequence that changes colour every 5 seconds or so - very eyecatching. But unlike our regular RGB LEDs, these have an inbuilt resistor for use on up to 13V, so...

Wide angle superbright RGB LEDs with an inbuilt controller that flashes between a range of colours. Has a 4.8mm wide angle case. Rated 20mA with a 110 degree viewing angle. You must use a resistor...

Wide angle superbright RGB LEDs with an inbuilt controller that flashes between a range of colours. Has a 4.8mm wide angle white diffuse case. Rated 20mA with a 110 degree viewing angle. You must use...

Wide angle superbright RGB LEDs with an inbuilt controller that slowly fades between a range of colours, in a 4.8mm wide angle case. Rated 20mA with a 110 degree viewing angle. You must use a...

Wide angle superbright RGB LEDs with an inbuilt controller that slowly fades between a range of colours, in a 4.8mm wide angle case. Rated 20mA with a 110 degree viewing angle. You must use a...

These LEDs have separate red and blue superbright chips, probably around 5000mcd for each colour. They are common cathode, so you can have either red, blue or both. They have a water clear case with...

This is a 5mm bicolour LED for general indication and other purposes. These LEDs have a standard 5mm body with two leads, but contain two LEDs connected in reverse-parallel. When the LED is connected...

These LEDs have a red and blue superbright chip and a controller that flashes the two colours alternately. The colour changes about 1-2 times per second, so these are very eyecatching LEDs. Clear 5mm...

This is a 5mm bicolour LED for general indication and other purposes. These LEDs have a standard 5mm body with two leads, but contain two LEDs connected in reverse-parallel. When the LED is connected...

These 5mm LEDs have separate red and green high brightness chips, so you can have either red or green (the green chip is brighter than the red). They are common anode with a milky diffuse case....

These 5mm LEDs have separate red and green high brightness chips, so you can have either red or green (the green chip is brighter than the red). They are common cathode with a milky diffuse case....

This is a standard brightness 5mm bicolour LED for general indication and other purposes. These LEDs have a standard 5mm body with two leads, but contain two LEDs connected in reverse-parallel. When...

These low cost LEDs have a 5mm flat top case with a conical indent at the end and disperse light in a wide pattern, both sideways and out of the flat end. They are RGB LEDs fitted with an inbuilt...

These RGB LEDs are fitted with an inbuilt controller chip that lets them produce a sequence of colour changes and mixes, which includes both fast and medium speed sequences. Ideal for eye-catching...

These RGB LEDs are fitted with an inbuilt controller chip that lets them produce a sequence of colour changes and mixes, which includes both fast and medium speed sequences. Ideal for eye-catching...

These RGB LEDs have a slow speed fading sequence that changes colour every 5 seconds or so - very eyecatching. Standard 5mm milky white diffuse case for good colour mixing. Should be used with a...