Standard brightness LEDs

A small, flat through-hole LED for general indication. A nice true red LED at a few tens of mcd at 20mA, so it's ideal for PCB indicators or whatever, without being too bright. Measures 3mm wide x...

These are from A-Bright Industrial in Taiwan. They are yellow tinted diffused 5mm standard brightness LEDs. Rated at 8mcd at 20mA with a 50 degree viewing angle. Rated wavelength is 585nm. Part...

These are 5mm diameter by around 6mm long and have a red bullet-shaped body. They are ideal for general use as indicators where a superbright LED is not required - ideal as 'eyes' on that bug robot!...

These are standard brightness 3mm green LEDs with a diffuse green tinted case. I don't have specs on these, but they are manufactured by Rohm, part number SLR-342MGT32. They appear to have a...

These are standard brightness 3mm green LEDs with a diffuse green tinted case and leads preformed into a 90 degree bend. I don't have specs on these, but they are part number BL-B214EL-10. They are...

These are standard brightness 5mm green (570nm) LEDs with a wide viewing angle and a diffuse green tinted case. Basic ratings are 10mcd @ 20mA with a viewing angle of 50-60 degrees. Forward voltage...

These standard brightness green LEDs have the 1.8mm short "tower" case and have a green tinted lens. A very compact light source for models etc. Specs are typical of small green LEDs, ie Vf around...

These are standard brightness yellow LEDs in a 3mm tinted diffuse case. Supplied on tape. They are Kingbright brand LEDs, part number L-934YD and are rated at 10-12.5mcd @ 20mA.

These 5mm LEDs incorporate a built-in resistor so they can be run on power supplies of up to 15 volts. They are standard brightness LEDs with diffuse, tinted cases. Datasheet is here.

These 5mm LEDs incorporate a built-in resistor so they can be run on power supplies of up to 15 volts. They are standard brightness LEDs with diffuse, tinted cases. Datasheet is here.

These 5mm LEDs incorporate a built-in resistor so they can be run on power supplies of up to 15 volts. They are standard brightness LEDs with diffuse, tinted cases. Datasheet is here.

These vintage LEDs are new old stock, made in the USSR, part number AL310A. Get a piece of LED history, once these are gone, they're gone! Specifications: Minimum luminous intensity Iv: 0.61 mcd at...

5mm orange resistor LED - Simple to use LED, produces a nice orange glow when connected directly to voltage source. No resistor needed as it already has it built into the LED. Orange lens, definitely...

Neat little rectangular yellow LED with a reduced width end for use as a panel indicator. Philips brand, part number CQV62. Specs are below: Peak Wavelength: 590nm Iv Min.(cd) Luminous Intensity:...

Bright red clear lens LED has a 5mm waterclear case. Vf is around 1.7V, Imax is 20mA. Wavelength is 650nm and viewing angle is 20 degrees. These would be a couple hundred mcd, so are in the medium...

These are standard brightness 3mm red LEDs with a diffuse red tinted case and leads preformed into a 90 degree bend. I don't have specs on these, but they are part number BL-B4131ERL-10. They are...