LED kits

(image for) Multifunction LED tester kit

Multifunction LED tester kit

As reviewed in DIYODE magazine, September 2021. This kit is much more versatile than cheap Chinese LED testers. Unlike the cheaper testers, this kit not only tests two-pin LEDs at a range of...
$38.00
Add:
(image for) Solderless LED torch kit

Solderless LED torch kit

This kit allows you to put together a simple LED torch (flashlight) which is powered by 3 x AAA batteries. Developed specifically for primary schools, where soldering is not allowed, rather than the...
$7.00
Add:
(image for) 9 volt battery LED torch kit - new 3 function version

9 volt battery LED torch kit - new 3 function version

Got old 9 volt batteries lying around? This kit makes good use of them! Every year when you change smoke alarm batteries, you end up with a handful of 9 volt batteries that are essentially okay, just...
$5.00
Add:
(image for) Emergency vehicle flasher simulation kit

Emergency vehicle flasher simulation kit

This simple kit uses one IC to alternately flash two pair of LEDs, much like the flashing lights on emergency vehicles. The kit runs from 9V to 12V DC and will run from a 9V battery, 12V battery or a...
$6.00
Add:
(image for) Forever Flasher kit

Forever Flasher kit

This simple kit uses one IC to flash a pair of LEDs at a low level using an extremely low average current. The kit runs from 9V DC and will run continuously from a standard 9V PP3 (transistor radio)...
$5.00
Add:
(image for) Forever Flasher kit PCB only

Forever Flasher kit PCB only

This is the bare PCB for our Forever Flasher kit. This simple kit uses one IC to flash a pair of LEDs at a low level using an extremely low average current. The kit runs from 9V DC and will run...
$0.50
Add:
(image for) Linear LED driver kit

Linear LED driver kit

This is a linear LED constant current driver that can provide up to 700mA of current to drive LEDs. While switchmode drivers are usually very efficient, they can have the drawbacks of higher...
$8.50
Add:
(image for) Mega Flasher kit

Mega Flasher kit

This simple kit uses one IC to flash a power LED at a rate of 0.5Hz to about 5Hz, adjustable with a trimpot. The pulse width is also adjustable from around 50% down to under 5%. Ideal for adding a...
$6.00
Add:
(image for) Simple touch switch with timer and white LEDs

Simple touch switch with timer and white LEDs

This neat little kit uses a 555 timer and some other components to make a touch activated light. Once the kit is built, just touch the touch plate and the white LEDs come on for the preset time as...
$3.00
Add:
(image for) Simple 2 LED flasher kit

Simple 2 LED flasher kit

This simple kit allows you to create a 2 LED alternating flasher. The circuit is based on a two transistor oscillator, one of the oldest electronic circuit designs. There are no ICs and it is a very...
$2.50
Add:

Shopping Cart  [more]

Your cart is empty.

Other interesting sites

(image for) Nuts About Mutts

(image for) Australia's leading renewable energy and sustainability org

(image for) Harry's Haven

(image for) LED ribbon sale

Manufacturers

Your IP Address is: 18.217.210.147
Copyright © 2024 LEDsales. Powered by Zen Cart